Page T-1
Repair and Service Manual
T
GENERAL SPECIFICATIONS
MPT
™
800
STANDARD EQUIPMENT:
WEIGHT (without batteries) 675 lbs. (306 kg)
TIRES 18 x 8.50 x 8 (4 ply rated)
TIRE PRESSURE 18 - 22 psi (120 - 150 kPa)
LOAD CAPACITY 800 lbs. (362 kg) (including operator, passenger, cargo and accessories)
GROUND CLEARANCE 4.75 in. (12 cm) at differential
MAXIMUM HEIGHT 65 in. (165 cm) with top
CHASSIS Welded high yield strength tubular steel with powder coat paint
BODY AND FINISH Front: Flexible, impact resistant panels. Color coat/clear coat finish
Rear: Lightweight, replaceable steel panels
SAFETY Dash mounted key switch, reverse warning indicator, ‘deadman’ accelerator control, integral
handgrip on hip restraints, manual forward/reverse selector with ‘neutral’, electric horn
STEERING WHEEL Dual handgrips
BRAKES Dual rear wheel mechanical, self-adjusting drum brakes. Combination service / park brake with
automatic parking brake release (accelerator kick-off)
FRONT SUSPENSION Heavy duty leaf springs with hydraulic shock absorbers
REAR SUSPENSION Heavy duty leaf springs with hydraulic shock absorbers
STEERING Self-compensating single reduction rack and pinion
DASH PANEL Scuff resistant with four drink holders
SEATING Formed fabric backed vinyl covers over cushion foam. Seating for operator and one passenger
MOTOR 36 volt DC high efficiency series wound, brazed armature, solid copper windings. 2.5 hp (1.9 kw) at
2700 rpm
DRIVE TRAIN Direct motor shaft connected to transaxle pinion shaft
ELECTRICAL SYSTEM 36 volt DC, six, 6 volt deep cycle storage batteries
SPEED CONTROL Solid State continuously variable speed controller, 300 amp rated
TRANSAXLE High efficiency differential with helical gears, 12.44:1 ratio
SPEED 13 mph ± .5 mph (21 kph ± .8 kph)
CHARGER PowerWise
™
portable, fully automatic
For locations outside US and Canada, refer to charger manufacturer for specifications and
recommendations.
Specifications subject to change without notice
To Next Page
Loading...
Need help?
General
