EACON EC5000 Series - Output Terminal Functions (Y1-Y4)

Positive rotation
lifting instruction
Down instruction
lower limit speed
upper limit speed
output frequency
consistent frequency
signal
Instruction of multi-function output:
SET NAME ILLUSTRATION
0 Fault switch off on when the AC drive fault
1 running
switch off when input right/opposite order or
innverter output voltage
2
frequency unanimous
————
3
any frequency unanimous
————
4
frequency test output frequency.≤frequency.test standard
5
frequency
test
output frequency.≥frequency.test standard
6
7
over torque testing(on)
over torque testing(off)
————
————
S7
S8
speed limit though there is no UP/DOWN order.
■If input jog and start order during running with UP/DOWN order, the jog
and start order has priority.
B08 Terminal Y1 sel setting limits:0~23 factory default:0
B09 Terminal Y2 sel setting limits:0~23 factory default:1
B10 Terminal Y3 sel setting limits:0~23 factory default:2
B11 Terminal Y4 sel setting limits:0~23 factory default:3
BB(base level blockade)
switch off when AC drive output is off
running mode
switch off when select panel operation
or frequency.order
AC drive run ready
switch off when AC drive has no error
and can run
timer function
automatic restart
switch off during error and restart
Ol（overload）alarm
Frequency. Given lost
transmission data
output 1
data output position 1 from RS485
communication
transmission data
output 2
data output position 2 from Rs485
communication
PID feed back lost
OH1 alarm
SET
NAME
ILLUSTRATION
Output frequency reach
the upper limit Freq
Running at Zero_speed
Auxiliary pump 1
Auxiliary pump 2
Output frequency reach
the lower limit Freq
8
9
10
11
12
13
14
15
16
17
18
21
19
22
23
20
EC5000
Description of Functional Parameter
EC5000
Description of Functional Parameter
- 70 - - 71 -
■ Setting: 2，setting example of “frequency unanimous signal”
Detection width
Consistent frequency signal
Released width
Result of expected
frequency
output frequency
ON
4HZ
+
-
2HZ
+
-