!
Product Manual Oria Thermostat
EAE KNX Oria Thermostat Oria Thermostat PM R1.0
©EAE!Technology!! ! ! ! www.eaetechnology.com!! ! ! Sayfa!19!/!50!
!
!
PushButton1- long -
value[temperature]
Enabled when “Long Press Data Type” selected as “4 byte value [floating point]
PushButton1- long -
value[0…4294967295]
Enabled when “Long Press Data Type” selected as “4 byte value [0…4294967295]”
Table 14
4.2.2, Push,Buttons,
Number of rockers should be selected in “General” tabs in parameters and should be chosen as compatible
with the device that will be configured. Push buttons are numbered from top to bottom – right to left, topmost
right push button as push button 1, near it push button 2, and so on. Push buttons can be configured as 4
different operations and 1 function to disable push button (No Function). Operation selection can be
configured from “Push Button N” (N: Push button number) tab, visible when “Rocker Operation” selected as “2
Push Buttons”. Every function enables different parameters and communication objects that will be explained
in the following chapters.
Push buttons can be used to send
on/off telegrams. (For more
information Chapter 4.2.2.1)
Push buttons can send on/off and
dimming telegrams. (For more
information Chapter 4.2.2.2)
Push button can control shutter,
venetian blind, blind, roller and
awning. (For more information
Chapter 4.2.2.3)
Push button can send predefined
values from different data types.
(Refer Section 4.2.2.4)
Table 15
Push buttons also have status LEDs which can be configured to indicate state of the operation that is
configured.
4.2.2.1' Switch
Selecting “Switch” as “Push Button Function“ enables to send 1 bit On(1)/Off(0) telegrams to the group address
that is linked to respective communication object. Pressing and releasing buttons can be assigned to different
commands (On, Off, Toggle and No Command). Status LEDs can be configured to notify the current status of
To Next Page
Loading...