- 23 -
3.4 Navigating LCD Screens
Job Notifiers
At the bottom-left corner of the auto and semi-auto job
screens, there is a textual display of the status of the
machine. A few examples of text that may be displayed are;
Machine Ready
A load has been detected as being placed on the turntable
and the machine is ready to run the selected job mode.
In Cycle
“In Cycle” will be displayed during operation of the selected
job mode.
Load Not Preset
The machine is ready to run the selected mode, but no load
has been detected as being placed on the turntable.
Film Carriage Not Home … Press RESET
The film carriage has not returned to its home position at
the bottom of the mast.
Machine Reset – In Progress
This message will be displayed after pressing the reset
button on the machine control panel. Once the machine
reset process has completed, this message will be cleared
from the screen.
To Next Page
Loading...
