13
1. Assembling the bracket.
A. One-piece bracket: Press the two small plastic ratchets into the sides
of the metal bracket as shown in the following illustration. Notice there are
letters molded into each ratchet. Place each ratchet into the bracket with
the letter "A" aligned with the dot stamped into the metal bracket. This po-
sition sets the transducer's coarse angle adjustment for a 14° transom. Most
outboard and stern-drive transoms have a 14° angle.
Align plastic ratchets in bracket.
B. Two-piece bracket: Locate the four plastic ratchets in the trans-
ducer's hardware package. Press two ratchets into the sides of the plastic
bracket and two on either side of the transducer as shown in the follow-
ing illustrations. Notice there are letters molded into each ratchet. Place
the ratchets into the bracket with the letter "A" aligned with the align-
ment mark molded into the bracket. Place the ratchets onto the trans-
ducer with the letter "A" aligned with the 12 o'clock position on the
transducer stem. These positions set the transducer's coarse angle ad-
justment for a 14° transom. Most outboard and stern-drive transoms
have a 14° angle.
Dot
To Next Page
Loading...
