1-800-345-6007 Page 13 www.ardisam.com
ORDERING REPORDERING REP
ORDERING REPORDERING REP
ORDERING REP
AIR PARTSAIR PARTS
AIR PARTSAIR PARTS
AIR PARTS
Parts can be obtained from the store where your mini
cultivator was purchased or direct from the factory. To order
from the factory, call or write to:
Please include the following information with your order:
1. Part numbers
2. Part description
3. Quantity
4. Model number and serial number
Ardisam, Inc.
1690 Elm Street, Cumberland, WI 54829
Phone (715) 822-2415 Main Fax (715) 822-2223
1-800-345-6007
Email info@ardisam.com
WWW.ARDISAM.COM
SERVICE INFORMASERVICE INFORMA
SERVICE INFORMASERVICE INFORMA
SERVICE INFORMA
TIONTION
TIONTION
TION
In the event that you experience trouble operating your mini
cultivator, begin by following the suggestions in the
troubleshooting guide in this section.
The guide will help you pinpoint the causes of common
problems and identify remedies.
For more complicated repairs, you may want to rely on
your retailer, an authorized mechanic or Ardisam, Inc.
(contact your retailer for a list of authorized mechanics in
your area). A parts catalog is included in this section.
We will always be glad to answer any questions you have,
or help you find suitable assistance. To order parts or
inquire about warranty, call or write us at the address
found in the next column under the section ordering repair
parts, or check out our website - www.ardisam.com.
SERVICESERVICE
SERVICESERVICE
SERVICE
, TROUBLESHOO, TROUBLESHOO
, TROUBLESHOO, TROUBLESHOO
, TROUBLESHOO
TING AND REPTING AND REP
TING AND REPTING AND REP
TING AND REP
AIRAIR
AIRAIR
AIR
IN CASE OF A SERVICE PROBLEM, DO NOT SEND
UNIT BACK TO RETAILER. CONTACT ARDISAM, INC.
AT 1-800-345-6007. WE WELCOME YOUR CALL.
TROUBLESHOOTINGTROUBLESHOOTING
TROUBLESHOOTINGTROUBLESHOOTING
TROUBLESHOOTING
Problem Possible cause Remedy/Action
Engine will not start
Engine runs rough, floods during
operation
Engine is hard to start
Engine misses or lacks power
Tines turn at idle
Engine runs, then quits
Engine revs too high
1. Flip switch to ON position
2. Connect spark plug wire to spark plug
3. Connect or charge battery
1. Clean or replace air cleaner
2. Turn off choke
3. Call factory
1. Drain old fuel and replace with fresh.
Use gas stabilizer at end of season
2. Make sure spark wire is securely
attached to spark plug
3. Clean carburetor, use gas stabilizer,
new gas can
1. Remove and clean
2. Clean or replace
3. Call factory
4. Replace spark plug and adjust gap
1. Adjust idle speed lower
2. Replace spring
1. Make sure gas cap vent screw is in
venting position
1. Add fuel to tank
1. Power switch off
2. Spark plug wire disconnected
3. Battery not connected or low charge
1. Dirty air cleaner
2. Choke partially engaged
3. Carburetor out of adjustment
1. Stale fuel
2. Spark plug wire loose
3. Dirty carburetor
1. Clogged fuel tank
2. Clogged air cleaner
3. Improper carburetor adjustment
4. Spark plug dirty, improper gap, or
wrong type
1. Idle speed too high
2. Broken clutch spring
1. Gas cap not venting
1. Low fuel in tank
Practice safety at all times. Engine must be turned off
and allowed to cool, and spark plug wire must be
disconnected before attempting any maintenance or
repair.
CAUTION
To Next Page
Loading...
Need help?
General
