To Next Page

To Previous Page

1-800-345-6007 Page 19 www.ardisam.com

The Border-Edger Kit is a useful tool for making clean cuts in the lawn along the borders of gardens, flower beds, walkways,

and driveways for a well manicured look.

1. Remove the cultivating tines.

2. Slide the border-edger attachment onto either side of the tine shaft. Make sure the hub collar of the edger tine faces

outward from the mini cultivator.

3. Slide one of the spacers onto the tine shaft next to the edger tine and insert the cotter pin through the hole at the end of

the tine shaft.

4. Slide the wheel onto the opposite side of the tine shaft.

5. Slide the remaining spacer onto the tine shaft next to the wheel and insert the remaining cotter pin through the hole at

the end of the tine shaft.

Before using the Border-Edger Kit, the drag stake should be removed from the mini cultivator and the wheels should be set

to the highest (top) position.

Be aware that the mini cultivator could unexpectedly

bounce upward, or jump forward if the tines strike

concrete, pavement, or other hard surfaces or hard

obstacles buried under ground.

CAUTION

BORDERBORDER

BORDER

-EDGER KIT INST-EDGER KIT INST

-EDGER KIT INST

ALLAALLA

ALLA

TION (OPTIONAL ACCESSORY)TION (OPTIONAL ACCESSORY)

TION (OPTIONAL ACCESSORY)

EK43 Border-Edger Attachment Kit

(fits both Models MC43 & MC43E)

EarthQuake MC43E User Manual

Other manuals for EarthQuake MC43E