EasyTouch ET-201 - Setting up Your Easytouch GCU Multi-Function Monitoring System; Setting Date and Time; Checking the Unit of Measurement

10
Setting Up Your EasyTouch
®
GCU Multi-Function Monitoring System
Setting Date and Time
NOTE:
Every time you insert batteries into the meter, it will enter setting mode automatically.
Set the correct time and date before you begin testing.
1. The meter will automatically enter the setting mode after you install the batteries.
2. Press “S” button to obtain the correct month.
3. Press “M” button to conrm the above setting and shift to the day setting.
4. Repeat the same steps to set the hour and minute.
5. When you nish setting, the meter will turn off automatically.
Checking the Unit of Measurement
Before you get started…
EasyTouch
®
GCU meter can measure your blood glucose, cholesterol, and uric acid in
the following units: