17
Caution:
Make sure that the code number shown on the screen is the same as the code number
printed on the cholesterol test strip vial, otherwise you may get incorrect measurement.
4. Hold the cholesterol control solution bottle upside down and
slowly squeeze the bottle to form a small drop. Discard the rst
drop of the solution, and let the second drop touch the edge of
the sample targeting area on the test strip. The control solution
will be drawn into the targeting zone automatically.
5. You will hear a “beep” sound. Close the cap of the control solution
immediately. The meter starts to count down from 150, and then
shows your result on the screen.
6. Check if the displayed cholesterol value falls within the acceptable
range shown on the test strip vial.
7. Remove the test strip from the meter and discard it.
To Next Page
Loading...