Eaton 5E Series - Recommended Placement; UPS Connection Procedures

7
4.2 Recommendedposions
PlacetheEaton5Eonaat,stablesurfaceinitsnallocaon.Alwayskeep6”or
150mmoffreespacenearUPSopeningsforvenlaon.
!
Installaonintowerposion
4.3 UPSconnecon
4.3.1 Power supply connecon
CheckthattheindicaonsonthenameplatelocatedonthebackoftheUPS
correspondtotheAC-powersourceandthetrueelectricalconsumponof
the total load.
ConnecttheUPStotheAC-powersourcewithcablethroughawalloutletequipped
withanearthconnector,usingyourequipmentcord.
1. Disconnecttheprotectedequipment,keepthepowercable
2. ConnectIECcableonprotectedequipmentside.
3. Connect IEC cable provided on UPS AC output side
4. Connect the power cable to UPS AC inlet
5. Connect the power cable to wall outlet