Installation
Eaton 9135 5000/6000 VA UPS User’s Guide 164201726—Rev 4 www.eaton.com/powerquality 18
To install the rail kit:
1. Adjust the UPS control panel orientation by slightly pulling out the control panel and rotating it 90°
counterclockwise (see Figure 4).
Figure 4. Adjusting the UPS Control Panel Orientation
2. Recommended. Remove the UPS battery tray (see Figure 5):
- Remove the UPS front cover (six screws).
- Place the front panel above the UPS.
- Remove the two battery retaining brackets (four screws).
- Slightly pull the battery tray, then lift it to extract it.
NOTE A ribbon cable connects the control panel to the UPS. Do not pull on the cable or
disconnect it.
To Next Page
Loading...
