Setting Description
Relay Outputs Configure the relay outputs.
Battery test Change the power level and duration for battery test.
Bypass Limits Change the bypass voltage or bypass frequency.
Screen Saver
Timeout
Change the screen saver timeout.
Meters Change the meters format.
Lamp Test Enable the lamp test.
HMI backlight Adjust the backlight brightness.
Control P/W level
1
Change the level 1 password, or remove the password on level 1. The default
value is 1111.
Control P/W level
2
Change the level 2 password. The default value is 1010.
Reset statistics Reset all statistics.
Minimum required
kVa
Change the minimum required kVa.
User kVa
Configure UPS output kVA rating.
Redundant level
Configure UPS internal redundancy level.
77..33 SSiiggnniinngg iinn
If the level 1 password is enabled, you need to sign in.
1. Press the lock icon in the top right corner of the screen.
2. Type in your password and press OK.
You are signed in.
3. Press Continue to return to the previous screen.
You have 3 attempts to type in the password. If an incorrect password is given more than 3 times, you
need to wait for 30 minutes before trying again.
Table 23. Default passwords
Level Name Password Description
1
USER NONE USER
2
CONTROL 1111 USER + CONTROL
EATON 93PM G2 UPS USER’S AND INSTALLATION GUIDE P-164000956
-
February 2021 www.eaton.eu 7744
To Next Page
Loading...
