Eaton C440/XTOE - C440-COM-ADP Communication Module; Mounting and Wiring

C440-COM-ADP Communication Module
10 C440/XTOE Electronic Overload Relay, DeviceNet MN04210002E—March 2011 www.eaton.com
C440-COM-ADP Communication Module
WARNING
Only apply 24 Vdc to the communication module fieldbus
connection. Use of any other voltage may result in
personal injury, property damage and damage to the
module.
Mounting and Wiring
The DeviceNet modules are designed to be installed on the
right side of the motor insight base unit or the
C440-COM-ADP.
1. Align module with side of Motor Insight base unit or
C440-COM-ADP.
2. Slide module bottom pegs into appropriate slots.
3. Rotate module up and gently click the base unit and
module together.
4. Connect DeviceNet cable and IO connector if desired.
C441X Communication Module
C440-COM-ADP
C440 to C440-COM-ADP Wiring
24 Vdc
C440-XCOM
1–24 Vdc
4–COM
5–DI
6–DO
C440-COM-
ADP
–
+
1–COM
2–24 Vdc
1–COM
2–D1
4–D0
5–24 Vdc
C
o
m
m
u
n
i
c
a
t
i
o
n
M
o
d
u
l
e
C440 DeviceNet.book Page 10 Friday, March 25, 2011 10:41 AM
For Immediate Delivery or Tech Support call KMParts.com at (866) 595-9616