EMR-4000 IM02602009E
WARNING indicates a hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous situation
which, if not avoided, could result in minor or moderate injury.
CAUTION, without the safety alert symbol, is used to address practices not
related to personal injury.
NOTICE is used to address information and practices not related to personal
injury.
FOLLOW INSTRUCTIONS
Read this entire manual and all other publications pertaining to the work to be
performed before installing, operating, or servicing this equipment. Practice all
plant and safety instructions and precautions. Failure to follow the instructions
can cause personal injury and/or property damage.
PROPER USE
Any unauthorized modifications to or use of this equipment outside its
specified mechanical, electrical, or other operating limits may cause
personal injury and/or property damage, including damage to the
equipment. Any such unauthorized modifications: (1) constitute "misuse"
and/or "negligence" within the meaning of the product warranty, thereby
excluding warranty coverage for any resulting damage; and (2) invalidate
product certifications or listings.
The programmable devices subject to this manual are designed for
protection and also control of power installations and operational devices
that are fed by voltage sources with a fixed frequency, i.e. fixed at 50 or 60
Hertz. They are not intended for use with Variable Frequency Drives. The
devices are further designed for installation in low voltage (LV)
compartments of medium voltage (MV) switchgear panels or in de-
centralized protection panels. The programming and settings have to meet
all requirements of the protection concept (of the equipment that is to be
protected). The User must ensure that the device will properly recognize
and manage (e.g.: switch off the circuit breaker) on the basis of User
selected programming and settings all operational conditions (failures).
Before starting any operation and after any modification of the
programming/settings, make a documented proof that the programming
and settings meet the requirements of the protection concept.
www.eaton.com 10
To Next Page
Loading...
