Eaton EMR-4000 - Switching the Breaker at the Panel

EMR-4000 IM02602009E
Switching the Breaker at the Panel
Manually switching a switchgear at the device panel is possible at the following switching authorities:
Local
Local and Remote
Assumed the device displays the main screen:
1. Press the »Menu« softkey.
2. Select the »Control« menu by using the »up« or »down« softkeys and press the »right« arrow softkey button.
3. Select the »Control« menu by using the »up« or »down« softkeys and press the »right« arrow softkey button.
4. A symbol for the switchgear and its status (ON, OFF, intermediate or disturbed) is displayed.
5. Dependent on the status (ON/OFF), the switchgear can be switched ON or OFF by the corresponding softkey.
The current position of the switchgear will be visualized by different symbols:
Breaker State Symbol
0
(Intermediate)
1
(OFF)
2
(ON)
3
(Disturbed)
www.eaton.com 399