EMR-4000 IM02602009E
Name Description
Wired Inputs.speed1-I State of the module input: Speed1
Wired Inputs.Local-I State of the module input: Local (Remote)
DI-8P X1.DI 1 Signal: Digital Input
DI-8P X1.DI 2 Signal: Digital Input
DI-8P X1.DI 3 Signal: Digital Input
DI-8P X1.DI 4 Signal: Digital Input
DI-8P X1.DI 5 Signal: Digital Input
DI-8P X1.DI 6 Signal: Digital Input
DI-8P X1.DI 7 Signal: Digital Input
DI-8P X1.DI 8 Signal: Digital Input
RO-4Z X2.ZI OUT Signal: Zone Interlocking OUT
RO-4Z X2.RO 1 Signal: Relay Output
RO-4Z X2.RO 2 Signal: Relay Output
RO-4Z X2.RO 3 Signal: Relay Output
RO-4Z X2.RO 4 Signal: Relay Output
RO-4Z X2.DISARMED! Signal: CAUTION! RELAYS DISARMED in order to safely perform maintenance while eliminating the risk of
taking an entire process off-line. (Note: Zone Interlocking and Supervision Contact cannot be disarmed). YOU
MUST ENSURE that the relays are ARMED AGAIN after maintenance
RO-4Z X2.Outs forced Signal: The State of at least one Relay Output has been set by force. That means that the state of at least one
Relay is forced and hence does not show the state of the assigned signals.
AnOut[1].Force Mode For commissioning purposes or for maintanance, Analog Outputs can be set by force. By means of this
function the normal Analog Outputs can be overwritten (forced).
AnOut[2].Force Mode For commissioning purposes or for maintanance, Analog Outputs can be set by force. By means of this
function the normal Analog Outputs can be overwritten (forced).
AnOut[3].Force Mode For commissioning purposes or for maintanance, Analog Outputs can be set by force. By means of this
function the normal Analog Outputs can be overwritten (forced).
AnOut[4].Force Mode For commissioning purposes or for maintanance, Analog Outputs can be set by force. By means of this
function the normal Analog Outputs can be overwritten (forced).
Event rec.Res all rec Signal: All records deleted
Waveform rec.Recording Signal: Recording
Waveform rec.Memory full Signal: Memory Full
Waveform rec.Clear fail Signal: Clear Failure in Memory
Waveform rec.Res all rec Signal: All records deleted
Waveform rec.Res record Signal: Delete Record
Waveform rec.Man. Trigger Signal: Manual Trigger
Waveform rec.Start1-I State of the module input:: Trigger event / start recording if:
Waveform rec.Start2-I State of the module input:: Trigger event / start recording if:
Waveform rec.Start3-I State of the module input:: Trigger event / start recording if:
Waveform rec.Start4-I State of the module input:: Trigger event / start recording if:
www.eaton.com 970
To Next Page
Loading...
