What does it mean if the green LED is on and the red LED flashes at 2Hz on my Eaton INV-4815E, while the AC output is normal?
This indicates either an SCR short fault or an auxiliary power supply fault. Turn the MBS to mains or inverter bypass mode to maintain the STS.
What does it mean if the red LED is on and other LEDs are off, while AC output is off on my Eaton INV-4815E Inverter?
This could mean several things: * The STS is in fault mode. * There is an over-temperature condition. * There is an overload. * There is an output short. Turn the MBS to mains or inverter bypass mode to maintain the STS. Check if the environmental temperature is higher and if anything is blocking the vent. Decrease or remove the loads, then shut down or remove the STS module. Then connect it back and restart it up.
General| Model | INV-4815E |
|---|---|
| Output Power | 1500W |
| Input Voltage | 48V DC |
| Battery Type | Lead Acid |
| Operating Temperature | 0°C to 40°C |
Describes the core product, its integrated AC power system, and its capabilities.
Outlines critical safety measures for handling, charging, and disposing of batteries.
Describes the steps for assembling the inverter chassis and other system frames.
Covers the procedures for connecting system wiring, including wire size considerations.
Explains the procedures for installing and removing STS and inverter modules.
Lists essential checks required before applying power to the system.
Details the step-by-step procedure for applying power to the system.
Explains how to monitor system status using the controller's LCD screen.
Guides on configuring system parameters, including password protection.
Outlines how to program various inverter and STS module parameters.
Provides routine maintenance schedules and recommendations for optimal performance.
Offers guidance for resolving system issues, errors, and LED status interpretation.
Describes the five positions of the Maintenance Bypass Switch (MBS) and their functions.
To Next Page