www.eaton.com Page 4-5
MP-4000 IB02602002E
Table 4-2. Monitor Mode Display.
SUB-
MENU
LINE DISPLAY COMPLETE HELP MESSAGE DESCRIPTION
10 LT2 XXXX LOAD BEARING TEMP 2 IN DEGREES
F or C
RTD reading - terminals 29, 30, 31.
11 AXT XXXX AUXILIARY TEMP IN DEGREES F or C RTD reading - terminals 33, 34, 35.
MONT
MTR
REAL TIME MOTOR DATA Motor monitoring data follows.
1 VER XXXX SOFTWARE VERSION NUMBER MP-4000 software version in use.
2 %I2T XXX PERCENT OF I2T TRIP LEVEL Percentage of thermal bucket used.
3 TUS XXX TIME IN MINUTES UNTIL NEXT START CAN OCCUR Displays largest amount of time in minutes among
three functions: anti-backspin, starts per unit time
and time between starts.
4 RMST XX REMAINING STARTS Number of starts remaining if starts per time is programmed.
5 OST XXX TIME LEFT ON OLDEST START IN MINUTES Remaining time allowed on oldest start for starts per time if
programmed. If motor start/time is exceeded, this is time in minutes
before restart is permitted.
6 ICM XXXX ADDRESS ON THE IMPACC NETWORK IN HEXADECIMAL Address of device if on INCOM communications network; only visible
if on network.
7 DI 1 OFF or
DI 1 ON
STATE OF DISCRETE INPUT 1 Current state of discrete input 1; ON = 120 Vac present, OFF =
120 Vac not present.
8 DI 2 OFF or
DI 2 ON
STATE OF DISCRETE INPUT 2 Current state of discrete input 2; ON = 120 Vac present, OFF =
120 Vac not present.
MONT
TIM
DATE AND TIME Current date and time with display format as programmed.
1 HH.MM XM CURRENT TIME 12-hour format.
or or
HH.MM 24-hour format.
2 MM/DD/YY CURRENT DATE Common format
or or
DD/MM/YY European / military format.
MONT V REAL TIME DATA FROM VOLTAGE RMS MEASUREMENTS
1 VA XXXX PHASE A TO GROUND VOLTAGE VAG RMS phase voltage.
2 VB XXXX PHASE B TO GROUND VOLTAGE VBG RMS phase voltage.
3 VC XXXX PHASE C TO GROUND VOLTAGE VCG RMS phase voltage.
4 VG XXXX GROUND VOLTAGE Neutral voltage differential (neutral to ground).
5 VPAV XXXX AVERAGE OF PHASE VOLTAGES Average of the RMS line to neutral voltages
VL avg. (Va+Vb+Vc)/3).
6 VAB XXXX LINE TO LINE VOLTAGE VAB RMS line to line voltage VAB.
7 VBC XXXX LINE TO LINE VOLTAGE VBC RMS line to line voltage VBC.
8 VCA XXXX LINE TO LINE VOLTAGE VCA RMS line to line voltage VCA.
9 VLAV XXXX AVERAGE OF THE LINE TO LINE
VOLTAGES
VLL average.
10 FRQ XXXX MEASURED FREQUENCY Frequency as measured on phase A voltage input.
MONT
VSQ
REAL TIME DATA FROM SEQUENCE VOLTAGES PHASOR
MEASUREMENTS
1 V1MG XXXX V1 PHASOR MAGNITUDE Magnitude of positive sequence voltage.
2 V2MG XXXX V2 PHASOR MAGNITUDE Magnitude of negative sequence voltage.
3 3V0 XXXX 3V0 PHASOR MAGNITUDE Magnitude of zero sequence voltage.
4 V1AG XXXX V1 PHASE ANGLE Phase angle of positive sequence voltage.
5 V2AG XXXX V2 PHASE ANGLE Phase angle of negative sequence voltage.
6 V0AG XXXX V0 PHASE ANGLE Phase angle of zero sequence voltage.
7 %VUB XXXX VOLTAGE PHASE UNBALANCE - IF POSITIVE THE RATIO OF
NEGATIVE TO POSITIVE SEQUENCE VOLTAGE - IF NEGATIVE
THE INVERSE
Voltage unbalance.
To Next Page
Loading...
