Page 10-2
www.eaton.com
IB02602002E MP-4000
dress on the network, using address switches on the I-PONI as shown
in Figure 10.1. Also, all devices must be communicating at the same
baud rate, which is usually be 9,600 baud, unless some old devices
are on the network.
For Modbus RTU, DeviceNet, and Ethernet connections, refer to the
instructions for those PONIs for further information.
PowerNet software is supplied with its own comprehensive instruc-
tions, which explain how to access MP-4000 data and control capabili-
ties at the host client computer.
10.5 PowerNet INCOM Communications Protocol
The communications messaging protocol specication for the MP-4000
is open and available to Users and communications systems integra-
tors without charge. Check the Eaton Power Management Products
web site, your distributor, or the factory for detailed specications and
documentation.
Figure 10.1 PONI Communications Module.
To Next Page
Loading...
