Eaton Powerware 5110 - Understanding UPS Indicators and Controls; On;Off;Test Switch Functionality

User’s manual
350 - 1500 VA
7
1023922
Revision A
Typical applications
Indicators
1. On/Off/Test Switch
One switch controls power to your equipment and performs a self-test to detect
overload/undercharge.
Turn on the UPS.
Press and hold the switch for more than one second and release the switch after the
beep. The UPS will start.
Turn off the UPS.
Press and hold the switch for more than one second and release the switch. The UPS
will shut down completely.
Perform Self-test.
The UPS will perform self-test for about 4.5 seconds when the UPS is turned on and
the utility power is present.