Eaton PowerXL DM1 Series - Page 108

98
Chapter 6 - Pump control application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Table 39. Multi-pump measurement (*DM1 Pro) (Cont.).
M8.2 - Output frequency (*DM1 Pro).
M8.2.1
Drive 1
ID 2222
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Provides the output frequency (Hz) of drive 1 while using the multi-pump mode.
M8.2.2
Drive 2
ID 2234
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Provides the output frequency (Hz) of drive 2 while using the multi-pump mode.
M8.2.3
Drive 3
ID 2246
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Provides the output frequency (Hz) of drive 3 while using the multi-pump mode.
M8.2.4
Drive 4
ID 2258
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Provides the output frequency (Hz) of drive 4 while using the multi-pump mode.
M8.2.5
Drive 5
ID 2270
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Provides the output frequency (Hz) of drive 5 while using the multi-pump mode.
M8.3 - Motor voltage (*DM1 Pro).
M8.3.1
Drive 1
ID 2223
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
Provides the motor voltage (Vac) of drive 1 while using the multi-pump mode.
M8.3.2
Drive 2
ID 2235
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
Provides the motor voltage (Vac) of drive 2 while using the multi-pump mode.
M8.3.3
Drive 3
ID 2247
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
Provides the motor voltage (Vac) of drive 3 while using the multi-pump mode.
M8.3.4
Drive 4
ID 2259
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
Provides the motor voltage (Vac) of drive 4 while using the multi-pump mode.
M8.3.5
Drive 5
ID 2271
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
Provides the motor voltage (Vac) of drive 5 while using the multi-pump mode.
M8.4 - Motor current (*DM1 Pro).
M8.4.1
Drive 1
ID 2224
Minimum value:
A
Maximum value:
A
Default value:
A
Description:
Provides the motor current (Amps) of drive 1 while using the multi-pump mode.
M8.4.2
Drive 2
ID 2236
Minimum value:
A
Maximum value:
A
Default value:
A
Description:
Provides the motor current (Amps) of drive 2 while using the multi-pump mode.
M8.4.3
Drive 3
ID 2248
Minimum value:
A
Maximum value:
A
Default value:
A
Description:
Provides the motor current (Amps) of drive 3 while using the multi-pump mode.