Eaton PowerXL DM1 Series - Page 190

180
Chapter 7- Multi-purpose application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Table 59. Outputs (Cont.).
P3.2.30
b
PI supervision enable
ID 1346
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Disabled; or
1 = Enabled.
Description:
Upper and lower limits around the reference are set. When the actual value goes above or below the upper limit and lower limit, the
delay timer will increment. When the actual value is within the allowed area, the delay counter decrements. After the delay time
expires, the relay output for PI supervision will be activated. This function is used for process value out of range faults.
P3.2.31
b
PI supervision display
ID 1828
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Enable DO;
1 = Warning (W/O S)/enable DO;
2 = Warning (W S)/enable DO; or
3 = Fault/enable DO.
Description:
Supervision display selection.
P3.2.32
b
PI supervision upper limit
ID 1347
Minimum value:
PI Process Unit Min
varies
Maximum value:
PI Process Unit Max
varies
Default value:
0.00 varies
Description:
Upper limit for PI feedback value used with the PI supervision controller.
P3.2.33
b
PI supervision lower limit
ID 1349
Minimum value:
PI Process Unit Min
varies
Maximum value:
PI Process Unit Max
varies
Default value:
0.00 varies
Description:
Lower limit for PI feedback value used with the PI supervision controller.
P3.2.34
b
PI supervision delay
ID 1351
Minimum value:
0 s
Maximum value:
3,000 s
Default value:
0 s
Description:
Defines the delay time that the PI feedback value must be out of range before activating the PI supervision output.
P3.3 - Analog output.
P3.3.1
b
AO mode
ID 227
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = 0 - 20 mA; or
1 = 0 - 10 V.
Description:
Defines the analog output mode to current or voltage.