Eaton Sefelec SXS56 - Connection to a Specimen; Connection for the Insulation Resistance Measurement and Dielectric Strength Test (any Model)

XS series operating manual
XS user manual v0.55 - 39 -
Connection to a specimen
Connection for the insulation resistance measurement and dielectric strength test
(any model)
Fig 5.5
 Connect the measurement probe (TE54, ...) on the B1 connector
 Secure the probe by tightening the knurled plastic ring
 Proceed the same way for the return probe (CO175) on the B2 connector.
 Connect the specimen to be tested as shown on the picture:
Fig 5.6
B2
Guard cable. Only necessary in Insulation resistance measurement for high
values ( R > 100 Gohms). WARNING : the voltage can reach -1000VDC
Specimen to be
tested
B1