EBARA E-SPD+ MT 2200 - Page 26

26
EN
C: FIXED SPEED
1. PARAMETERS 2. DISPLAY 3. LOG 4. MANUAL 5. ADVANCED PARAMETERS 6. FINE TUNING
1.2 SPEED SETPOINT
2.01 MODULE
TEMPERATURE
5.01 LANGUAGE
5.54 DRY RUNNING ALARM
ACTIVE
6.10 ALARMS RESET
5.08 MINIMUM WORKING
FREQUENCY
5.46 SCHEDULE
OPERATION 2
5.16 CHANGEOVER TIME
5.59 MOTOR THERMISTOR
TYPE
5.24 SPEED IN 2
5.64 FACTORY DEFAULT
RESET
5.04 TRANSD. PRESSURE
MIN VALUE (4mA)
5.44 PROGRAM START
TIME 1
6.04 SWITCHING
FREQUENCY
5.48 PROGRAM STOP
TIME 2
6.08 MODBUS BAUDRATE
5.18 DIGITAL INPUT 1
5.61 PARAMMETER LOCK
5.28 SPEED IN 3
5.37 SLAVE 1V SPEED
SETPOINT
5.02 UNITS OF PRESSURE
5.43 SCHEDULE
OPERATION 1
5.55 DRY RUNNING
TRIGGER LEVEL
6.11 RESET NUMBER OF
START-UPS
5.09 MAXIMUM WORKING
FREQUENCY
5.47 PROGRAM START
TIME 2
6.07 MODBUS ADRESS
5.17 PUMP KICK INTERVAL
5.60 MOTOR THERMISTOR
TRIGGER LEVEL
5.26 DIGITAL INPUT 3
5.32 SPEED IN 4
5.05 TRANSD. PRESSURE
MAX VALUE (20mA)
5.45 PROGRAM STOP
TIME 1
5.58 VOLTAGE ALARM
ACTIVE
5.22 DIGITAL INPUT 2
5.11 MAXIMUM NUMBER
OF PUMPS ON
6.09 MODBUS PARITY
5.20 SPEED IN 1
5.62 SET DATE AND TIME
5.30 DIGITAL INPUT 4
5.38 SLAVE 9V SPEED
SETPOINT
5.41 RELAY OUTPUT 1
2.09 DIGITAL INPUT 1
2.4 0-10V INPUT
2.12 DIGITAL INPUT 4
1.4 MOTOR CURRENT
2.02 ANALOGUE
SIGNAL 1
2.10 DIGITAL INPUT 2
2.05 MOTOR
THERMISTOR
2.13 RELAY OUTPUT 1
2.07 HOURS WORKED
2.15 SOFTWARE VERSION
1.5 ROTATION
DIRECTION
2.03 ANALOGUE
SIGNAL 2
2.11 DIGITAL INPUT 3
2.06 VOLTAGE
HOURS
2.14 RELAY OUTPUT 2
2.08 START-UP NUMBER
2.16 POWER CONS.
OF PUMP
2.17 POWER CONS. OF
NETWORK
5.42 RELAY OUTPUT 2