EBARA E-SPD+ MT 2200 - Page 27

EN
27
EN
D: CONSTANT TEMPERATURE
1. PARAMETERS 2. DISPLAY 3. LOG 4. MANUAL 5. ADVANCED PARAMETERS 6. FINE TUNING
1.3 TEMPERATURE
SETPOINT
2.01 MODULE
TEMPERATURE
5.01 LANGUAGE
6.01 PROPORTIONAL
CONSTANT
5.59 MOTOR THERMISTOR
TYPE
5.58 VOLTAGE ALARM
ACTIVE
6.09 MODBUS PARITY
5.08 MINIMUM WORKING
FREQUENCY
5.51 MIN TEMPERATURE
ALERT LEVEL
5.21 TEMPERATURE IN 1
5.62 SET DATE AND TIME
5.06 TEMP. SENSOR MIN
VALUE (4mA)
5.47 PROGRAM START
TIME 2
6.03 PI DIRECTION
5.17 PUMP KICK INTERVAL
5.11 MAXIMUM NUMBER
OF PUMPS ON
5.54 DRY RUNNING ALARM
ACTIVE
6.07 MODBUS ADRESS
5.29 TEMPERATURE IN 3
5.39 SLAVE 1V
TEMPERATURE SETPOINT
5.43 SCHEDULE
OPERATION 1
5.03 UNITS OF
TEMPERATURE
5.46 SCHEDULE
OPERATION 2
6.02 INTEGRAL
CONSTANT
5.16 CHANGEOVER TIME
5.60 MOTOR THERMISTOR
TRIGGER LEVEL
6.10 ALARMS RESET
6.11 RESET NUMBER OF
START-UPS
5.09 MAXIMUM WORKING
FREQUENCY
5.52 MAX TEMPERATURE
ALERT LEVEL
6.04 SWITCHING
FREQUENCY
5.64 FACTORY DEFAULT
RESET
5.26 DIGITAL INPUT 3
5.33 TEMPERATURE IN 4
5.42 RELAY OUTPUT 2
5.07 TEMP. SENSOR MAX
VALUE (20mA)
5.48 PROGRAM STOP
TIME 2
5.18 DIGITAL INPUT 1
5.61 PARAMMETER LOCK
5.22 DIGITAL INPUT 2
5.25 TEMPERATURE IN 2
5.12 MAIN PUMP STOP
DELAY
5.55 DRY RUNNING
TRIGGER LEVEL
6.08 MODBUS BAUDRATE
5.30 DIGITAL INPUT 4
5.40 SLAVE 9V
TEMPERATURE SETPOINT
5.44 PROGRAM START
TIME 1
5.41 RELAY OUTPUT 1
2.09 DIGITAL INPUT 1
2.4 0-10V INPUT
2.12 DIGITAL INPUT 4
1.4 MOTOR CURRENT
2.02 ANALOGUE
SIGNAL 1
2.10 DIGITAL INPUT 2
2.05 MOTOR
THERMISTOR
2.13 RELAY OUTPUT 1
2.07 HOURS WORKED
2.15 SOFTWARE VERSION
1.5 ROTATION
DIRECTION
1.8 STOP TEMPERATURE
OFFSET
2.03 ANALOGUE
SIGNAL 2
2.11 DIGITAL INPUT 3
2.06 VOLTAGE
HOURS
2.14 RELAY OUTPUT 2
2.08 START-UP NUMBER
2.16 POWER CONS.
OF PUMP
2.17 POWER CONS. OF
NETWORK
5.45 PROGRAM STOP
TIME 1