34
EN
EDCBAMax.Min.Default
UnitsDescriptionPar.
Programming Application
Notes
5.55
5.56
5.57
5.58
5.60
5.61
5.62
5.63
5.64
5.59
X
X
X
X
X
X
X
10
1
YES
YES
0,5
NO
NO
NO
NO
90
99
NO
NO
99,9
YES
YES
YES
YES
OFF
PTC
NTC
25
5
YES
YES
1
NO
NO
NO
NO
OFF
%
Sec
kohm
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Allows you to fine-tune the sensitivity of the protection
triggering by detection of dry running.
Time from when the system calculates a low water level
until the moment the alarm is activated for this reason.
Parameter for enabling or disabling the detection of the
broke pipe.
Parameter for enabling or disabling the alarm due to
a power cut.
By this parameter, set the trigger level of motor
thermistor connected.
YES: Editing the values of the parameters is locked.
NO: Editing the values of the parameters is unlocked.
To change this parameter from YES to NO, you must
enter the password 1357 or another password generated
previously by the user.
When you change this parameters to “YES” this screen
for editing the date and time will appear. Once editing is
completed, the parameter returns to “NO”.
If you change this parameter from “NO” to “YES” the stop
frequency search wizard will be launched.
To reset the unit and leave it with the factory settings,
change this parameter to “YES” and after you have
entered the code 1357 the unit will launch the start-up
wizard.
By this parameter, select the type of motor thermistor
available for motor protection.
DRY RUNNING TRIGGER
LEVEL
DRY RUNNING ALARM
DELAY
BURST PIPE ALARM
VOLTAGE ALARM ACTIVE
MOTOR THERMISTOR
TRIGGER LEVELL
PARAMETER LOCK
SET DATE AND TIME
STOP FREQUENCY SEARCH
WIZARD
FACTORY DEFAULT RESET
MOTOR THERMISTOR TYPE
(1) In B mode, is only available with 2 transducers
(2) In E mode, is only available with 2 transducers
To Next Page
Loading...
