Need help?Do you have a question about the ECD SmartDRY SD-10 and is the answer not in the manual?
General| Weight | Not available |
|---|---|
| Frequency | 50/60 Hz |
| Type | Desiccant |
| Voltage | 220V |
| Drying Technology | Desiccant |
Details how to visually inspect the unit for damage upon delivery and document any issues.
Explains the process for handling concealed loss or damage claims with the carrier.
Specifies power requirements and connection procedures for the dry cabinet.
Overview of the main display, showing current conditions and access to programmable functions.
Reminds users to review safety and installation guidelines before proceeding.
Simple instruction to connect the cabinet to a properly grounded power outlet.
How to set and adjust the target Relative Humidity level for the SmartDRY™ cabinet.
Configuring RH and Temperature alarms, including setting delay times and enabling them.
Guidelines for safely cleaning the interior and exterior of the dry cabinet.
Procedures for identifying and replacing the SmartDRY™ dryer module.
Step-by-step guide for disassembling, replacing, and reassembling the power board.
Instructions for removing, swapping, or returning the RH/Temperature probe for calibration.
Procedure for replacing the SmartBAKE™ heater module.
Troubleshooting steps for when the main display does not power on or remains black.
Diagnosing and resolving issues where the cabinet fails to reach the desired RH set point.
Troubleshooting steps for when the bake temperature set point is not achieved.
Explains common system alerts like Door Open, Dryer Failure, Probe Failure, and Heater Failure.
To Next Page
