SD Series Dry Cabinets Setup and Operation Manual | A55-7379-00 Rev: 2.0.0 Page 13
5.0 SETUP & INSTALLATION
The installation of the SmartDRY™ Cabinet may be performed by the end user. Local, city, county, or other ju-
risdictions may govern the use of this equipment. If you have any questions about local requirements, please
contact the appropriate local agency.
The SmartDRY™ Cabinet is intended for indoor use only, at room temperatures between 15°C and 35°C, at no
greater than 80% relative humidity (at 25°C) and <2, 000 meters (6,561ft) elevation.
5.1 POWER SOURCE
The power requirements are listed on the cabinet serial number label. The supply voltage should not vary
more than 10%.
POSITION THE UNIT TO ALLOW USER ACCESS TO THE POWER CORD FOR MAINS DISCONNECT.
PLUG THE UNIT INTO A PROPERLY GROUNDED AND RATED RECEPTACLE OF THE CORRECT TYPE.
THE VOLTAGE AT THE RECEPTACLE SHOULD NOT VARY MORE THAN 10% FROM THE LISTED RAT-
ING.
To Next Page
Loading...