14
FRONT HANDLE INSTALLATION
Tools Required: Screwdriver.
Parts Required: Front Handle, Handle Support, Four (4) 5mm x 35mm
screws with captivated washers, four (4) 5mm nuts.
1. Position front handle on drive shaft, DO NOT tighten screws yet.
2. Stand in a comfortable operating position with attachment as-
sembled and move front handle for comfortable operation. Tighten
handle screws.
R + M
2
PRE - OPERATION
FUEL
Fuel Requirements --
Gasoline - Use 89 Octane [ ] gasoline known to be good quality.
Gasoline may contain up to 10% Ethanol (grain alcohol) or 15% MTBE
(methyl tertiary-butyl ether). Gasoline containing methanol (wood
alcohol) is NOT approved.
Two Stroke Oil - A two-stroke engine oil meeting ISO-L-EGD Standard
(ISO/CD 13738), must be used. Echo brand Premium 50:1 oil meets this
standard. Engine problems due to inadequate lubrication caused by
failure to use an ISO-L-EGD approved oil, such as Echo Premium 50:1
Two-stroke Oil, will void the two-stroke engine warranty. (Emission
related parts only are covered for two years, regardless of two-stroke
oil used, per the statement listed in the EPA Phase I/California Emis-
sion Defect Warranty Explanation.)
Mixing - Follow directions on the oil container.
To Next Page
Loading...
Need help?
General
