18
STARTING WARM ENGINE
WARNING DANGER
Attachment should not rotate at idle. If attachment rotates, readjust
carburetor according to Carburetor Adjustment instructions in this
manual or see your ECHO dealer, otherwise serious personal injury
may result.
1. Stop Switch - Start/Run.
Move stop switch button/lever (A) away from the STOP position.
2. Primer - Pump Bulb.
Pump primer bulb (C) until fuel is visible in the “Clear” fuel return
line (D).
3. Starting.
Lay unit on a flat, clear area and pull recoil starter handle/rope (E)
until engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
STOPPING ENGINE
1. Release Throttle. Allow engine to idle for a minute.
2. Stop Switch - Stop. Move stop switch button/lever (A) to STOP
position.
WARNING DANGER
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using unit again.
C
D
E
E
A
A
To Next Page
Loading...
Need help?
General
