P
RO
A
TTACHMENT
S
ERIES
O
PERATOR
'
S
M
ANUAL
17
OPERATION
• Provide all operators of this equipment with the Operator's Manuals
and instructions for safe operation.
• Before starting the unit, equip yourself and any other person
working within the specified Safety Zone provided in your attach-
ment manual with the required Protective Equipment and clothing.
• During operation, the complete unit, especially the drive shaft
housing and the attachment bearing housing may become very hot,
too hot to touch. Avoid contact during and immediately after
operation.
STARTING COLD ENGINE
WARNING DANGER
The cutting attachment should not move at idle. If cutting attach-
ment moves, readjust carburetor according to "Carburetor Adjust-
ment" instructions in this manual or see your ECHO Dealer,
otherwise serious personal injury may result.
1. Stop Switch - Start/Run.
Move stop switch button/lever (A) away from the STOP position.
2. Close Choke - Cold Start.
Move choke lever (B) to Cold Start Position.
3. Primer - Pump Bulb.
Pump primer bulb (C) 10 times. Fuel will be visible in the “Clear”
fuel return line (D).
4. Start - Pull Rope.
Lay the unit on a flat clear area and pull the recoil starter handle (E)
until engine fires.
5. Open Choke - Run.
Move the choke lever to the OPEN-RUN position. Restart engine if
necessary and allow to warn up running at idle for several minutes.
NOTE
If engine does not start with choke in “RUN” position after 5 pulls,
repeat instructions.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
C
B
D
E
E
A
To Next Page
Loading...
Need help?
General
