DPAS-2100
9992223804716
© 12/2022 ECHO Incorporated
Equipment
Use only ECHO attachments. Serious injury may result from the use of a non-
approved attachment combination. ECHO Incorporated will not be responsible
for the failure of cutting devices, attachments or accessories which have
not been tested and approved by ECHO. Read and comply with all safety
instructions.
• Do not attempt to modify this product. Serious injury can result from
the use of any modied product. DO NOT put them where they will
become part of any waste landll or municipal solid waste stream.
Take them to a certied recycling or disposal center.
• Check unit for loose or missing nuts, bolts, and screws. Tighten or
replace as needed.
• Inspect shield for damage and ensure that shield is properly
installed, and that the cutoff knife is securely in place. Replace if
either is damaged or missing.
• Check that the cutting attachment is rmly attached and in safe
operating condition.
• Manufacturer recommended exible non-metallic line is installed in
the trimmer head.
• Assure that power switch, lock-off lever switch, operator presence
switch, and enable button all work properly.
• Check that handle and harness (if included) are installed and
adjusted for safe, comfortable operation. See Assembly Section for
proper adjustment.
Moving parts can amputate ngers or cause severe injuries. Keep hands,
clothing and loose objects away from all openings.
• ALWAYS stop unit and make sure all moving parts have come to
a complete stop before assembling unit, removing obstructions,
clearing debris, or servicing unit.
• DO NOT start or operate unit unless all guards and protective covers
are properly assembled to unit.
• ALWAYS remove battery or unplug unit before adjusting guards or
handles.
• ALWAYS stop machine, remove battery and inspect if unit strikes a
hard object, or if excessive vibration is felt.
• NEVER reach into any opening while the unit is running. Moving
parts may not be visible through openings.
SAFETY
To Next Page
Loading...
Need help?
General
