38
Maintenance and care
Remove dust and dirt from between fins.
Before each use, remove accumulated debris from bottom en-
gine intake grille located between the fuel tank and starter.
Cleaning silencer
Remove the silencer cover.
Remove the spark arrester screen cover and the screen from
the silencer body.
Clean carbon deposits from silencer components.
Replace the screen if it is cracked, or has holes burned
through.
Assemble the components in reverse order.
Check fuel system
Check before every use.
After refuelling, make sure fuel does not leak or exude from
around fuel pipe, fuel grommet or fuel tank cap.
In case of fuel leakage or exudation there is a danger of fire.
Stop using the machine immediately and request your dealer
to inspect or replace.
1. Cylinder fins 2. Air intake
1. Silencer
2. Spark arrester screen
3. Screen cover
4. Silencer cover
NOTE
Carbon deposits in silencer will cause drop in engine out-
put.The spark arrester screen must be checked periodically.
1. Fuel tank cap
2. Fuel grommet
3. Fuel pipe
To Next Page
Loading...
Need help?
General
