39
Maintenance and care
Check spark plug
Check plug gap. Correct gap is 0.6 mm to 0.7 mm.
Inspect electrode for wear.
Inspect insulator for oil or other deposits.
Replace plug if needed and tighten to 15 N·m - 17 N·m (150
kgf·cm to 170 kgf·cm).
Lubricating drive shaft
Inspect the drive shaft every 100 hours of use and replenish
grease if it is insufficient.
Angle transmission
Remove plug from angle transmission.
Add grease, if necessary, using low pressure pump.
Reinstall plug.
Checking the blade
Use only blade designated for this model by the manufacturer.
When a crack is noticed on the blade, do not use it but replace
with a new one.
Ensure that the blade is correctly fitted in accordance with the
instructions.
a: 0.6 - 0.7 mm
1. Drive shaft
NOTE
Use good quality lithium multi grease.
1. Angle transmission 2. Plug (Bolt)
NOTE
Use good quality lithium multi grease.
Do not overfill housing.
To Next Page
Loading...
Need help?
General
