To Next PageTo Next Page
Need help?Do you have a question about the Ecodan 150 Standard and is the answer not in the manual?
Details on the discharge pipe from safety devices to the tundish, including diameter and material requirements.
Requirements for tundish installation, location, and air gap compliance for safety valve discharge.
Specifications for the discharge pipe from the tundish, including length, fall, and material considerations.
Guidance on selecting suitable Mitsubishi Electric Ecodan Air Source heat pumps for the pre-plumbed cylinders.
Specifies water quality parameters and system preparation steps, including cleansing and inhibitor use.
How to connect the solar models to a pumped solar primary circuit using 22mm copper pipe or BSP connections.
Using a solar differential temperature controller for accurate temperature control and preventing overheating.
Steps for filling the unit, checking connections, expansion vessel pressure, and purging air, followed by system checks.
Guides on DHW circulation, primary circuit operation, and setting automatic system by-pass valves.
Covers regular inspection of safety valves, strainers, and expansion vessel charge pressure.
Detailed steps for cleaning strainers, descaling immersion heaters, and removing/replacing them.
Post-maintenance steps to ensure the system is refilled and operating correctly after servicing.
Crucial safety warnings, commissioning record importance, and handling operational faults.
Guides on setting immersion heater temperature, heat pump heating, and understanding flow performance.
General| Brand | Ecodan |
|---|---|
| Model | 150 Standard |
| Category | Water Heater |
| Language | English |
