24
Use Left/Right arrow keys to set the desired time (3 – 30 seconds). Default is 3 seconds.
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection and return to previous screen.
1) The system is shipped with this feature disabled for all 3 liquid products. There is a row of 3 connectors and
OPEN plugs (S1-S3) located at the bottom of the IO board. This simulates an always-full product. If the jumper
is connected (‘S’ and ‘-‘ pins are closed), an empty product alarm will be displayed and logged.
2) The ‘+’ pins are reserved for the capacitive sensor (future use). Do not connect the ‘+’ pins to standard sensor.
If the installation uses only 1 float sensor (1 liquid product pail) with 3 washing machines, the wiring needs to use
jumpers so any washer can determine an Out Of Product Alarm.
2.2.7 Submenu #2.7 Quick Setup>Alarm Volume
Adjust the alarm volume using this screen.
To Next Page
Loading...
