Ecolab Aquanomic - Page 26

26
Setup WE>Select Washer #3.1
1. WASHER 1
2. Washer 2
3. Washer 3
System Menu #3.0
1. WASHER SETTINGS
2. Detergent
3. Bleach
4. Finish
5. Optional Form Select
6. Optional Solid Product4
7. Optional Liquid Product
8. Select Textile Type
9.Reset Setup Menu
10. Reset All
1. WASHER SETTINGS 1. WASHER 1
Submenu #3.1.1.1 Setup Menu>Washer 1>WE Name:
Washer Name can only be set up using an Ecolab tablet or a mobile device.
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
Setup Menu>Washer 1>Name #3.1.1.1
Washer’s Name
1. WE NAME
Submenu #3.1.1.2 System Menu>Washer 1> Capacity:
Set up washer capacity. The wash formulae are entered into the system in Grams, and will be scaled to
match the recommended dose for the washer capacity if the washer size is changed or the formulas are
copied to another washer with a different capacity.
Example: If the recommended dose for Product X is 10 Gram/CWT, the Condor will scale doses for
each washer based on washer capacity:
Washer Size
Dose
50-lb
5 Gram
200-lb
20 Gram
Use the Left/Right arrow keys to select the desired number (Range 22-135 lbs, Default 99 lbs).
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
Setup Menu>Washer 1>Capacity #3.1.1.2
99.0 LB
2. CAPACITY
Submenu #3.1.1.3 System Menu>Washer 1> Chart Stop:
Set up Chart Stop feature for each washer, if desired. The default setup is No.
Press SK#3 <Save> to save selection. Press <Back> to cancel selection.
For information on Chart Stop Wiring, please refer to Installation Manual.