Ecolab Aquanomic - Page 27

27
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
Setup Menu>Washer 1>Chart Stop #3.1.1.3
1. NO
2. Yes
3. CHART STOP
1. NO
Submenu #3.1.1.4 System Menu>Washer 1> Additional Post Flush Time:
Set up the additional post-flush time for each washer. Flush time is dependent on several factors (distance
from Main Dispenser to washer, elevation of flush tubing, water pressure, etc.) and it is important that a
reasonable flush time is set.
An adequate post-flush time is very important to minimize the risk of cross-contamination between incompatible
products. The post-flush time must be long enough to ensure that all product is completely flushed from the system.
Use the Left/Right arrow keys to set the desired flush time (Range 30-300, Default 30 seconds)
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
Setup Menu>Washer 1>Additional Post Flush #3.1.1.4
30.0 SECS
4. ADDITIONAL POST FLUSH TIME
Submenu #3.1.1.5 System Menu>Washer 1>WE Signal Filter Time:
The Signal Filter Time for each washer is the minimum signal length required before controller deems it a
valid signal. It is important to select a reasonable filter time (i.e. if filter time is too short stray voltage or
electrical noise could register as a valid signal).
Use the Left/Right arrow keys to select the desired number (Range 0-29, Default 2 seconds)
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
Setup Menu>Washer 1>Signal Filter #3.1.1.5
2 SECS
5. WE SIGNAL FILTER TIME
Submenu #3.1.1.6 System Menu>Washer 1>WE Signal Mode:
Set up washer in either standard signal mode or MicroMode.