28
1- Standard Mode: The system dispenses when it receives supply signals from the intended washer.
Manual formula selection is required. Press SK#3 <Save> to save selection. Press <Back> to cancel
selection.
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
6. WE SIGNAL MODE
Setup Menu>Washer 1>Signal Mode #3.1.1.6
1. Standard
2. Micro Signal Mode
1. STANDARD
2- Micro Mode: Formula selection is automatically performed via an accurately-timed supply signal input
from a fully-programmable microprocessor-controlled washer. Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
6. WE SIGNAL MODE
Setup Menu>Washer 1>Signal Mode #3.1.1.6
1. Standard
2. Micro Signal Mode
2. MICRO SIGNAL MODE
There are two equations used to calculate the MicroMode signal time (Input 1 ON time). The following table
shows the MicroMode signal time for each formula considering these two equations:
Input 1 ON Time (seconds)
The default equation is T=2F+1.
Press SK#2 <Edit> to select the desired MicroMode signal time equation. Press SK#3 <Save> to save
selection. Press <Back> to cancel selection.
System Menu >Washer 1 #3.1.1
1. WE Name
2. Capacity
3. Chart Stop
4. Additional Post Flush Time
5. WE Signal Filter Time
6. WE Signal Mode
7. WE Formula Reset Option
6. WE SIGNAL MODE
Setup Menu>Washer 1>Signal Mode #3.1.1.8
1. Standard
2. Micro Signal Mode
2. MICRO SIGNAL MODE
Setup Menu>Washer 1>Micro Mode #3.1.1.8.2
1. T=2F+1
2. T=5F
Note: Connect Micro Mode Signal to Signal#1
1. T=2F+1
Refer to Installation Manual for information on MicroMode Wiring.