From this screen the operator can Copy, Edit and Reset Formulae. It also allows the user to pull
up a formula summary.
Formula Summary
This screen lists the products assigned to each wash step (steps 1-6).
For example, in the screen above P1 is assigned to washer Step 1. Therefore, once S1 has been
validated, P1 will be dosed into the wash wheel. P2 is assigned to washer Step 2, and will be
dosed once S2 has been validated. P3 is assigned to washer Step 3, and will be dosed once S3
has been validated. There is no product assigned to washer Steps 4-6.
Formula Summary – Additional Information
This screen displays the Delays (in seconds), Chart Stop Delays, and Chart Stop Timers (if Chart
Stop is Enabled) for up to 6 wash steps (WE Input 1-6).
Note: All Chart Stop Delay and Timers are set to 00 (minutes).
2.4.5 Submenu #4.0 Formula Menu --- Reset Formula
Formula>Select Washer>Washer 1> #4.2
Capacity=99 LB; F1. WHITE TOWELS
1. Copy Formula?
2. Edit Formula?
3. Formula Summary
4. Reset Formula?
4. RESET FORMULA?
Formula>Washer 1> #4.2.3
Capacity=99 LB; F1. WHITE TOWELS
Reset Formula?
From this screen the operator can Copy, Edit and Reset Formulae. It also allows the user to pull
up a formula summary.
Reset selected formula to factory default settings. A pop-up screen will appear and
ask the user to confirm the selection.
2.5 Submenu #5.0 Prime Pump – Used only for optional liquid pumps
Priming liquid pumps delivers chemical product and flush water to the washing machine. Ensure washer is idle and empty
prior to performing a liquid pump prime and ensure the chemistry is properly flushed and drained from the washing
machine after the procuedure.
To Next Page
Loading...
