Ecolab Aquanomic - Page 43

43
2.7.2. Submenu #7.2 View System Info>Load Counts
System Info #7.0
1. Last Visit
2. Load Counts
3. Empty Alarm
4. Formula Not Finished
5. System Error
6. Condor Software
7. OPL Software
8. IO Software
9. WE Signal Software
10. Formula Select Software
11. Water Temperature
2. LOAD COUNTS
System Info>Load Counts>
#7.2
1. TOTAL LOAD COUNTS
2. Washer 1 Load Counts
3. Washer 2 Load Counts
4. Washer 3 Load Counts
5. Clear All Load Counts
1. TOTAL LOAD COUNTS
System Info>Load Counts> #7.2.1
Cycle LB
1. Washer 1 1 35
2. Washer 2 2 70
3. Washer 3 3 105
System Info>Load Counts> #7.2
1. Total Load Counts
2. WASHER 1 LOAD COUNTS
3. Washer 2 Load Counts
4. Washer 3 Load Counts
5. Clear All Load Counts
2. WASHER 1 LOAD COUNTS
System Info>Load Counts>
Washer 1 #7.2.1
Cycle LB
1. Towels 1 35
2. Wht Sheets 2 70
3. Color Sheets 3 105
4. PERSONALS 4 140
…
15. Rags 0 0
4. PERSONALS 4 140
System Info>Load Counts>
#7.2
1. Total Load Counts
2. Washer 1 Load Counts
3. Washer 2 Load Counts
4. Washer 3 Load Counts
5. CLEAR ALL LOAD COUNTS
5. CLEAR ALL LOAD COUNTS
System Info >Load Counts
Clear All Load Counts #7.2.5
Clear All Load Counts?
Screen
Description
7.2
Load Counts
Select load counts to view total system load counts, load counts for each washer, or to clear
load counts.
<ENTER>
Proceed to view load counts
7.2
Logged Load Counts
Load counts may be viewed at the system level (i.e. Total Load Counts) or individually for each
of the 3 washers. Load counts for each washer will be further broken down to Load Counts for
each formula.
<ENTER>
Use Up/Down arrow keys to scroll to desired load counts or clear load counts.
7.2.1
Total Load Counts
Total load counts displayed for each of the 3 washers.
Narrow down Load Counts for a certain period of time (provided the controller
clock has been properly set up – Quick Setup > 4. Date & Time)
Clear all load counts
7.2.2
Washer Load Counts
For the selected washer, load counts for each of the 15 formulae are shown.
Narrow down Load Counts for a certain period of time (provided the controller
clock has been properly set up – Quick Setup > 4. Date & Time)