Ecolab Aquanomic - Page 44

44
Clear washer load counts
7.2.5
Clear Load Counts
This screen allows the user to clear all Load Counts for the entire system. Confirm selection.
<YES>
Clear all load counts
2.7.3. Submenu #7.3 View System Info>Empty Alarm
System Info #7.0
1. Last Visit
2. Load Counts
3. Empty Alarm
4. Formula Not Finished
5. System Error
6. Condor Software
7. OPL Software
8. IO Software
9. WE Signal Software
10. Formula Select Software
11. Water Temperature
3. EMPTY ALARM
System Info>Empty Alarms #7.3
1. Product 1 1
2. Product 2 2
3. Product 3 3
9. Clear All Empty Alarms?
4. CLEAR ALL EMPTY ALARMS?
System Info >Empty Alarms
Clear All #7.3.2
Clear All Empty Alarms?
Screen
Description
7.0
System Info
Proceeding from here will allow the user to view or clear empty alarms for each product.
<ENTER>
Proceed to view empty alarms for each product
7.3
Empty Alarms
Logged Empty Alarms are displayed for each of the 4 products. An option is also available to
clear Empty Alarms for the entire system.
Narrow down Empty Alarms for a certain period of time (provided the controller
clock has been properly set up – Quick Setup > 4. Date & Time)
7.3.2
Confirm Clear Empty Alarms
Select Yes or No to confirm the selection
<YES>
Confirm clear Empty Alarms