9. Use the scrollbar to set the time/minutes.
10.
Press the Next button.
ð
Screen change for setting: ‘Pulse duty factor’
11. Use the scrollbar to set the minutes.
12. Select seconds.
13. Use the scrollbar to set the seconds.
14.
Press the Next button.
ð
Screen change for setting: ‘Capacity
’
15. ‘Set the decimal places of the capacity in litres
’ using the scroll bar.
16. Select the field for entering the value after the decimal point.
ð
The colour changes to dark blue, which indicates that the field is ready for input.
17. ‘Set decimal places of the capacity in litres
’ using the scrollbar.
18.
Press the Next
button.
ð
Screen change for setting: ‘day of the week’
19. ‘Select
’ days of the week.
ð
A check mark is set in the selection field.
20.
Press the button.
ð
The pump saves the settings and switches back to the previous screen.
21.
Go to [Main menu] by pressing the button .
Set [Operating mode] [Timer] [Interval programme]:
1. Open the main menu.
2. - [T
imer] [Interval programme] .
3.
Press the Next button.
ð
Screen change to the selection of the timer interval (interval programme)
4. [Interval programme] .
ð
Screen change for setting: ‘Interval programme
’ - ‘Switch-on duration’
5. Use the scrollbar to set the time/hours.
6. Select time / minutes.
7. Use the scrollbar to set the time/minutes.
8.
Press the Next
button.
ð
Screen change for setting: ‘Switch-off duration
’
9. Use the scrollbar to set the minutes.
10. Select seconds.
11. Use the scrollbar to set the seconds.
12.
Press the Next
button.
ð
Screen change for setting: ‘start state’
13. If required, select ‘
Start condition OFF’.
ð
A check mark is set in the selection field.
14.
Press the Next
button.
ð
Screen change for setting: ‘Capacity
’
15. Set the litres with the scrollbar
.
16. Select the millilitre range.
Comissioning and operation
49 417101656 Rev. 01-10.2019
To Next Page
Loading...
