Claim for any damages as soon as you notice them.
Damage claims can only be filed within the applicable period for
complaints.
DANGER!
Danger of commissioning a damaged component by the transport
device
If transport damage is detected when unpacking the system or system
components
, you must not install or commission any part of the system.
According to installation / comissioning of an damaged component
uncontrollable error may occur because of the use of aggressive metering
there can be irreparable damage to personnel and / or equipment.
Suspended loads
WARNING!
Danger of injury due to suspended loads!
There is a risk of injury when transporting and mounting or dismounting the
device due to suspended loads.
–
Never stand under or in the pivot range of suspended loads.
– Only use approved lifting equipment and suspension devices of
sufficient load-bearing capacity.
– Do not use cracked or worn slings.
– Only use slow transport movements because of the heavy weight.
– Make sure that no people, objects or obstacles are in the transport pivot
range during transportation.
– Only move loads under supervision.
– Deposit the load when leaving the workplace.
– Use personal protective equipment.
Transport by crane
n Crane and lifting gear must be designed for the weights involved.
The owner/operator
must have the crane and lifting gear checked regularly by experts.
n Crane operator (> 18 years) must be trained to operate the crane and named in
writing.
n Observing the attachment points, attach the transport unit to the crane and transport it
with the appropriate lifting gear (e.g. crossbeam, belts, multiple-point suspension gear,
ropes). Do not walk under suspended loads!
n During transportation, use the lifting eyes on the transport unit where available, and
observe the transport instructions.
Fig. 1: Transport by crane (schematics)
a Suspension points below the load b Transport using lifting eyes
General information
7 417101656 Rev. 01-10.2019
To Next Page
Loading...
