1 Metering hose
2 Union nut
3 Clamping piece
4 T
apered part
5 O-ring
6 Pressure valve
7 Suction valve
1. T
rim the hose to the precise length.
2. Slide the union nut (pos. 2) and Clamping piece (pos. 3) over the hose and attach
the hose to the tapered part up to the stop collar (pos. 4).
3. Insert the O-ring (pos. 5) into the valve groove and tighten the union nut.
4. Place the suction pipe in the delivery bundle.
5.4.2 Electrical installation
Personnel:
n
Qualified electrician
DANGER!
Risk of electric shock
Pay attention to disconnect the power supply immediately and to secure
against accidental switch-on!
CAUTION!
Mains Connection
The electrical connection must be made in accordance with the applicable CE
directives. In addition, the respective country regulations and local
EVU regulations
must be observed.
Assembly, mounting and installation
33 417102233 Rev. 3-03.2019
To Next Page
Loading...
