Ecolab Elados EMP III-E10 - Electronic Version; Mounting Diagram; Setup; Setup; Mounting

417102233 Betriebsanleitung EMP III E00, E10
- 34 -
Rev. 02-11.13
5 Setup / Mounting
5.1 Setup
Pos.
Description
1
Diaphragm breakage sequence
2
Suction valve
(connection on the suction side)
3
Pump head
4
Pressure valve
(connection on the pressure side)
Flow direction of the metering
medium
Fig. 5.1
5.1.1 Electronic version
Fig. 5.2
Pos.
Description
1
Control knob for stroke length
2
on/off switch
3
green LED (ready for use)
Leistungsbeschreibung:
Equipment
Function
(only E00)
Terminal box on
motor
Continual operation without
ON/OFF switch, without
operation lamp
(E00/E10)
Mechanical stroke
adjustment
Metering capacity setting
(only E10)
On/off switch
Continual operation (max.
stroke frequency)
(only E00)
Green LED
Pump ready for operation
5.2 Mounting diagram
Pos.
Description
1
Overflow valve
2
Pressure control valve
3
Replacement method: Multifunction valve
4
Suction pipe / bottom admission valve
NOTE
The metering valve, pressure control valve and
pressure relief valve can be replaced by a
multifunction valve (MFV) from our product range,
which combines all of these functionalities.
Fig. 5.3