Ecolab Lubo-DryExx - System Settings Access; Navigating System Settings; Changing System Time and Date; Valve Version Selection and Assignment

417101634_Lubo-DryExx_Advanced
- 48 -
Rev. 07-01.15
7.3.8 System settings
fig. 7.23
• To go to the “System settings”

Press "Ecolab"
7.3.8.1 System settings
fig. 7.24
• To go to sub menues
 Press desired button
• To switch language (circular)
 Press „language/Sprache“
• To leave “System settings“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:

Press " "
After leaving the picture with button „Back“ you see again the „Main Screen”.
7.3.8.1.1 Time
fig. 7.25
• To change values
 Press „Date“ or „Time“
• To take a value into PLC
 Press „time to PLC“
• To leave “Time“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:
 Press " "
After leaving the picture with button „Return“ you see again the „System settings”.
7.3.8.1.2 Valves
fig. 7.26
The version selection is forces bound to the used
hardware and must agree with it!
• To appoint the used version
 Press desired button „Advanced 16V“ or
„Advanced 24V“
• To go to „valve assignment“
 Press „valve assignment“
• To leave “ valve assignment“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:

Press " "
After leaving the picture with button „Back“ you see again the „System settings”.