STORM™ - SETTLING RATE MONITOR
INSTALLATION, OPERATION & MAINTENANCE MANUAL
ESTDS-STORM-IOM - REV K
Page 4 of 31
4 INSTALLATION
4.1 STORM Panel Location
The STORM™ unit should normally be installed on the Thickener bridge, adjacent to the centre-
well. Common installation practice is to use the bridge handrails to mount the unit. The
STORM™ cabinet is provided with four (4) mounting brackets located at the rear of each corner
of the cabinet.
Figure 4-1 : Panel Mounting Details
4.2 Sample Hose Location
The sample point should be located :-
• In the thickener centre well.
• In such a position as to give a good cross-section of the thickener feed.
To Next Page
Loading...
