EcoQuest LaundryPure - Silver Ion Probe Replacement

16
Disconnect the probe’s electrical
connector by pressing the 2 tabs to
unlock, then pull straight out.
Unscrew the Silver Ion Probe
and remove.
Apply Teflon tape to the threads
of the new Silver Ion Probe.
Insert the Silver Ion Probe into
the pipe and tighten with a
wrench. Do not overtighten.
Plug the probe’s electrical
connector into the new
Silver Ion Probe.
2
1
3
4
5
S I L V E R I O N P R O B E R E P L A C E M E N T
Electrical Shock Hazard.
Disconnect power before attempting service. Failure to follow these
instructions can result in death, fire, or electrical shock.
WARNING:
When the SERVICE lamp on the front of your LaundryPure unit is
lit, the Silver Ion Probe (item# US70962) needs to be replaced.
Contact your EcoQuest Dealer for replacement probes.
SERVICE INDICATOR LAMP
• To reinstall the cover, see page 17.
Silver Ion Probe Replacement.
Failure to change your Silver Ion Probe annually may void warranty. Also,
failure to replace Probe may result in leakage around the Probe area.
CAUTION: