9
CALIBRATION/RESET BUTTON
S Y S T E M S E T U P
Turn on the cold
water valve.
Check all hoses to ensure
no water is leaking.
Tighten if necessary.
Start your washer. The UV
light should come on and
you should see water begin
to flow (when looking
through the view window).
NOTE:
Your LaundryPure should automatically turn on when
your washing machine starts, and turn off approximately
5 minutes after your washing machine turns off.
1
0/7%2).
3%26)#%
0/7%2/54
/54,%4
#/..%#44/#/,$7!4%2/.,9
).,%4
$)3#/..%#4"%&/2%3%26)#).'
2
3
If your LaundryPure fails to come on when you turn on your
washing machine (UV lamps don’t light)
: Press the small
calibration/reset button on the bottom left of the LaundryPure
until the UV bulbs light (the amount of time required for the
LaundryPure to calibrate to your washing machine will vary
depending on make and model of your washer).
If your LaundryPure automatically starts up (UV lamps are lit)
before your washing machine is turned on: Hold the
calibration/reset button until the LaundryPure turns off. After the
LaundryPure is off, restart your washer.
Once the LaundryPure is calibrated properly, it will not
require calibration again (unless you replace your washing
machine). Check all hose connections again for water
leaks.
4
5
To Next Page
Loading...